Make sure that the screw is properly aligned with itsĬorresponding hole, and avoid over tightening. NOTICE: When reinstalling a screw, you must use a screw of the correctĭiameter and length. The placemat provides the number of screws and the sizes. Windows Me from and install it before you upgrade theīefore removing and replacing components, photocopy the screw placemat as a tool to lay out and keep track of the screws. NOTICE: If the computer is running Microsoft® Windows® MillenniumĮdition (Me), you need to download the operating system update utility for Upgrading the microprocessor, replacing the reserve battery, or Flash BIOS update program floppy disk or CD (required only when.Number 1 magnetized Phillips screwdriver.Hold a component such as a microprocessor Do not touch theĬomponents or contacts on a card. Handle components and cards with care.I/O panel on the back of the computer chassis. Unpainted metal surface on the surface of the computer, such as the To dissipate any static electricity while you work, periodically touch an.Remove any installed device in the media bay.NOTICE: To avoid damaging the system board, you must remove the mainīattery and secondary battery (if present) before you service the computer. Remove the primary battery from the battery bay and the secondaryīattery from the media bay, if a secondary battery is in use.Close the display and turn the computer upside down on a flat work.Remove any installed PC Cards or plastic blanks from the PC Card.Disconnect all other external cables from the computer.To avoid possible damage to the system board, wait 10 to 20 secondsĪnd then disconnect any attached devices.Disconnect the computer from the electrical outlet.Turn off the computer and all attached devices.Save and close any open files, and exit any open programs.Make sure that the work surface is clean to prevent scratching the.NOTICE: To avoid damaging the computer, perform the following steps before NOTICE: Unless otherwise noted, each procedure in this manual assumes thatĪ part can be replaced by performing the removal procedure in reverse order. Damage or inoperability due to servicing not authorized by Dell is NOTICE: Only a certified service technician should perform repairs on yourĬomputer. Removing and Replacing Parts : Dell Inspiron 8100

Replacing hard drive in dell laptop